Elevator equip rm. /mech rm.require an outlet Elevator pits: 10 fc minimum at floor level everywhere. %%EOF
Industrial trucks within the scope of ASME B56. Cables used in Class 2 power-limited circuits shall be permitted, provided the cables are supported and protected from physical damage and are of a jacketed and flame- retardant type. Seismic requirements for elevators and escalators were clarified. Elevator Electrical Service, Conductors and Devices: a. Thank you again. Each elevator shall have a serial number assigned by the division or authority having. Protecting its foundation is an essential part of maintaining your elevator in excellent condition, safe and smooth for passengers. Suitable 110V service in the hoistway, midway of travel (see layout) or connected to terminals in elevator controller for car light service (elevator contractors Chapter 3 Use and Occupancy Classification, Chapter 4 Special Detailed Requirements Based on Occupancy and Use, Chapter 5 General Building Heights and Areas, Chapter 7 Fire and Smoke Protection Features, Chapter 15 Roof Assemblies and Rooftop Structures, Chapter 25 Gypsum Board, Gypsum Panel Products and Plaster, Chapter 30 Elevators and Conveying Systems, 3006 Elevator Lobbies and Hoistway Opening Protection, 3009 Elevator Accessibility Requirements for the Physically Handicapped, 3011 Electrolysis Protection for Underground Hydraulic Elevator Cylinders, 3012 Alterations to Electric and Hydraulic Elevators and Escalators, 3013 Clearance Requirements Between Elevator Doors for Elevators Inside a Private Residence, Chapter 32 Encroachments Into the Public Right-of-Way, Chapter 33 Safeguards During Construction, Appendix B Chapter 9B-52 F.A.C. Pit. %PDF-1.6
%
Each elevator car interior must have a support rail on at least one, The inside surface of support rails must be 1, A bench or seat may be installed on the rear. <>
Direction of travel of each elevator car. The height of the hoistway shall be measured from the, Protection of elevator hoistway door openings is not required where the elevator serves only, Protection of elevator hoistway door openings is not required at the level(s) of. endstream
endobj
287 0 obj
<. Now I know that I can not. <>/ExtGState<>/ProcSet[/PDF/Text/ImageB/ImageC/ImageI] >>/MediaBox[ 0 0 612 792] /Contents 4 0 R/Group<>/Tabs/S/StructParents 0>>
The following ASME A17.1 and ASME A17.3 rules are hereby amended to read as follows: Rule 3.11.3 of ASME A17.3 is amended to read as follows: All newly installed underground hydraulic pressure cylinders shall be encased in outer plastic containment to minimize electrolytic corrosion between the metal cylinder and ground cathode. The following features serving each occupant evacuation elevator shall be supplied by both normal power and Type 60/Class 2/Level 1 standby power: Wires or cables that are located outside of the elevator hoistway, machine room, control room and control space and that provide normal or standby power, control signals, communication with the car, lighting, heating, air conditioning.