If a container is "racked," diagonal corner-to-corner wall measurements will not match each other. Start discharging with most of the discharge coming from forward, but include some from midships and after tanks. A container must be reinspected before its DD Form 2282 decal expires30 months from the last inspection. Bottom end rails are lateral structural members located at the bottom edge of the front end of the container between the corner fittings. When a vessel is inclined by an external force, the ___________. The total area of the vents or the overflow shall be at least 125% of the area of the fill line. To "shore up" the main deck the for the cargo means to ___________. The rain gutter is a channel attached to the door header on some containers to divert water away from the doorway. Which would you NOT use to report the amount of anchor chain out? A gusset is a reinforcement plate attached to or between adjacent structures to reinforce the component and provide additional strength. which statement about container splices is true Which statement is TRUE concerning hawser towing? Which statement is TRUE concerning lifeboat installations on Great Lakes vessels? As a standard operating procedure you should first . Strengthen the main deck by placing pillars underneath it in the tween-decks. The lashings on a stack container with interlocking fittings restrain the forces that cause _____________. Which statement concerning storm surges on the Great Lakes is FALSE? B. path. This will be corrected by . hb```\@($0Q+F@-k, b$zIqs%IN ryZ~@":w V00pt40vt0f(%3:p.e`g`g1)YH1tN?iF`8iiM@A There are three types of end-opening containers: Which tensioning device is used with wire rope lashing to secure vehicles aboard Ro-Ro vessels? A placard may be a rigid sign in a placard holder or a sticker applied directly to the container. Non-structural Component - Roof reinforcement plates. report), and DD Form 2282 decal (if applicable). A welder's hammer is used to remove slag from weld to determine weld serviceability and to chip away at rusted structures to determine corrosive severity.